Apistogramma sp. "Wilhelmi"
A new tank was set up in the clubhouse to accomodate a pair of wild Apistogramma couple.
Apistogramma sp. "Wilhelmi" characteristic purple chin.
Their natural habitat is in river with soft and acidic water, therefore blackwater extracts are added to the water, giving the water a yellowish cast.

When it was just added to the tank, the colour and purple chin was not as obvious.
Posted by: SPAQ
The Monthly Green
January 2010 Issue
Eriocaulon mato grosso
There has been a new addition to the planted tank in SP Aquaculture Club.

This plant is known as Eriocaulon mato grosso or more commonly as Gu Jing.
Gu Jing in its planted glory.
Posted by: SPAQ
DIY JOURNAL
January 2010 Issue
This issue is the continuation of the last DIY Journal on the DIY canister filter, below are the materials used and instructions:
Container
Sponge filter parts

Parts with plastic tube removed
Marking on the cover
Cut hole
Fit in parts and give fast twist to fix it in position
Top view
Bubble tea straw cut to length
Fit into inlet tube
Make sure around 0.5cm gap between container bottom and straw to allow water flow
Seal up with silicon glue
Bottom view seal both sides
Close up of glue
Close up of bottom (Suggested: Partially loosen the tube to apply glue then fit it back allowing the glue to fill in the creaks between container cap and tube)
Top close up
Cut up plastic cup removing top and bottom part using the mid portion
Apply glue and attach to bottom of container to create gap for water flow and support sponge
Filter media and ceremic rings
Cross-section diagram
Water is drawn into filter via water pressure and is forced through filter media thus filtering it.Air pumped into outlet is less dense than water and thus floats up carying water along with it. The pressure exterted by the air is expelled through the shortest route, which is the outlet. When pressure is expelled from outlet, inlet have less pressure thus creating flow.
Water lever in both inlet and outlet is the same; the air and air pressure naturally acts as an external force to allow the water at outlet to flow above the inlet
Estimated Price if produced in bulk:
*= can be used for more than one filter
Container $3.90
Sponge filter $1.50
*Silicon Glue 1 tube $3.00
*Bubble Tea straws $1.50
*Sponge or Cotton $1.00
*Ceremic Rings $2.00
Plastic Cup $0.00 (can be taken from food courts etc.)
Total $13.40 (taken into consideration several of the more expensive things can be used for more than one filter)
Tools used: a simple penknife, scissors, a saw can be also used instead of a penknife
Posted by: SPAQ
SINGAPORE POLYTECHNIC
OPEN HOUSE 2010
Between 7th to 9th of January, SP Aquaculture club were showcased at the SP Open House. Throughout the 3 days, they were promoting the club and the way of aquaculturing to secondary school leaver and current SP Students. There are even free shrimps given to SP Students that signed up for the club during the open house.
A newly designed tank was moved to the booth to show students and visitors some of the activities that the club are doing.
Harlequin Rasboras in the tank that was displayed during Open House
Tank was also setup for visitor to catch fish with their bare hand.
This is not an easy task... without sufficient technique, the fish will just slip out of your hand.
Shrimps that were packed and prepared to be given out.
The aquaculture club logo sticker on the bag have instruction on how to take care of the shrimp.
Tiger and Bee shrimp that were given out were sponsered by Mr Sam.
Posted by: SPAQ